Skip to main content
FREE Delivery!|(504) 389-7856

Webster Parish, Louisiana

Bulk Aggregates for Patios in Sarepta, LA

Free delivery to Sarepta on every order, with loads arriving in as fast as 2 business days.

Delivering to Sarepta, LA

Open any product to see your delivered price.

  • Order from 1 ton
  • As fast as 2 business days
  • Dump truck delivery

Good starting points for Louisiana projects

All 27 products

From order to drop-off

  1. 1

    Pick the material and quantity.Open a product to see the delivered price for Sarepta.

  2. 2

    Choose a delivery date at checkout.As fast as 2 business days for most Sarepta addresses.

  3. 3

    Clear a drop spot.The truck tips the load where you mark it. Note low wires or branches when you order.

Not sure how much you need?

Enter length, width and depth and the calculator returns the cubic yards and tons for your project.

Open the calculator

If you are planning a patio, a driveway or a drainage run in Sarepta, LA, gravel and aggregate delivery starts with the base under it. Louisiana Rock Supply sells bulk material by the ton or the yard and delivers it across Webster Parish.

For most flatwork and paver work around here, that base is 610 limestone. The local ground is sandy loam over clay, so what you put under the slab matters as much as the slab itself.

Ground and Conditions in Sarepta

Across the northern and western uplands, the surface is sandy loam over Tertiary sands and clays. The ground rolls rather than sits flat, with sandy ridges and clay down in the draws.

That sandy loam takes water in quickly. The clay beneath it does not, so water moves sideways down the slope and gathers in the low spots.

A paver patio or a slab poured on a base that is too thin shows the failure first at the edges. The bedding layer shifts, the joints open, and the surface rocks underfoot.

The fix is a base course that is thick enough to carry the load and a bedding layer that stays put. That is a material choice before it is anything else.

Bare sandy slopes cut gullies fast once the cover is gone. In the draws, moving water scours the ditch and stream banks instead.

Erosion work here follows the slope, not a water table. Where water runs, a clean open stone moves it; where soil has to hold, you build with fill and cover.

Work runs year round in this part of the state. Wet clay in the draws is what stops a compaction pass, so plan around the weather rather than the calendar.

Materials for Sarepta Projects

Bedding under pavers and flatwork is where the choice of material shows up years later. The base course carries the load, and the bedding layer sets the finished grade.

610 Limestone, also called #610 or 610 base, is the Louisiana base material for driveways, parking pads, shed pads and the compacted layer under flatwork. The stone dust up to about two inches binds it, so it hardens as it is rolled.

Crushed Concrete is recycled Portland cement concrete, crushed and screened to a dense graded size with the fines left in. Louisiana permits it as a Class II base course material, and it is a real alternative to quarried base.

For the setting bed itself, Mason Sand is the finest washed sand and gives a smooth, even layer under pavers, brick and block. Stone Screenings do the same job as crusher fines and also pack down as a top for a path.

Washed Sand, which Louisiana yards also call river sand, beds pipe and flatwork and backfills where a clean fine material is wanted. It does not bind the way a fines-bearing base does.

Clean stone handles water where the clay will not. #57 Limestone is about 3/4 inch with no fines, the usual choice for drainage and concrete work, and Drain Rock is washed clean for French drains, foundation perimeter drains and downspout runs.

Smaller clean sizes cover the finer work. #67 Stone suits drainage trenches, pipe bedding and concrete, while #8 Crushed Stone at roughly 3/8 inch beds pavers and handles fine drainage.

Where a slope has to be held, RipRap is the angular stone for bank and ditch edges and slope protection. Rounded stone will not do that job, because it does not lock together.

For raising low ground out of the water, Select Fill compacts instead of settling, so it belongs under a base course and not under a lawn. Top Soil is the growing layer for lawns and beds over ground that is more often heavy clay than anything a lawn wants.

Delivery to Sarepta and the Surrounding Area

You order online, choose a quantity by the ton or by the yard, and pick a delivery date at checkout. A dump truck then tips the load on your site.

Each product page has a calculator to help you size the load before you order. Getting the quantity close matters more than anything else on a bulk order.

Louisiana Rock Supply delivers to Sarepta and to the rest of Webster Parish, including Minden, Springhill, Sibley, Cotton Valley and Doyline.

Questions About Gravel in Sarepta

What gravel is best for a driveway in Sarepta?

It depends on whether you are building the drive or topping it. For a new drive, 610 limestone is the base, because the fines bind it and it hardens as it is rolled.

For the surface over a finished base, #57 Limestone is the clean open graded choice at about 3/4 inch. Crushed Concrete works as a base course too, and Louisiana permits it as a Class II material.

How much material will my project need?

That comes down to the area you are covering and the depth you are building to. Quantities are ordered by the ton or by the yard, and each product page has a calculator to help you size the load.

Have your measurements ready before you order, and the number you get is the number you order.

Order Bulk Aggregate for Your Sarepta Project

Size the load with the calculator on the product page, then order the quantity you need by the ton or the yard. Louisiana Rock Supply delivers 610 limestone, clean stone, sand and fill across Sarepta and Webster Parish.

Place your order online and a truck will tip it on site.

Before you order

What buyers ask us before they order.

What gravel is best for a driveway in Sarepta?

It depends on whether you are building the drive or topping it. For a new drive, 610 limestone is the base, because the fines bind it and it hardens as it is rolled. For the surface over a finished base, #57 Limestone is the clean open graded choice at about 3/4 inch. Crushed Concrete works as a base course too, and Louisiana permits it as a Class II material.

How much material will my project need?

That comes down to the area you are covering and the depth you are building to. Quantities are ordered by the ton or by the yard, and each product page has a calculator to help you size the load. Have your measurements ready before you order, and the number you get is the number you order.

What happens if the weather turns?

We would rather move a delivery than tear up your ground. If the site is too wet for the truck on the day, we will call you and rebook. Tell us in advance about any part of the approach that does not drain and we will plan around it.